4) You will need to have on hand slow drain tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
To find a plumber, all one has to do is flip and run through the Yellow Pages or do a search on the Internet. From there you will see loads of plumber whom are advertising to get your job. The next thing you should do as a consumer is to take remember that there some plumbers whom advertise 2 different ads in the same place. Thus it is important to not water line repair make a rush decision. Look through the list of plumbers available and call a few (minimum of 3).
You don't want to be paying your plumber to clear the area before they start work particularly if you are paying an hourly rate. Empty cupboards and make sure there is nothing that may cost the plumber time and you money gaining access to the job.
Clean the hole in the gutter railing first. It must be free of any debris, so you may want to clean the entire drain channel using a proper cleaner. In this way, you will have a clean surface area which will allow you to repair the hole more easily.
If the area around the fan isn't clean and dry, or if dust or any sort of growth has accumulated on the blades or inside the exhaust duct, it may be a warning sign of excess moisture build-up. Clean the water line repair fan and area well. Then double- check that the fan is operating properly.
The work area should always be clean and free of trash and clutter. The cleaner and less clutter there is in a Plumbers' work area, the better able a plumber will be to make sure that his job goes as smoothly as possible.
Is your garbage disposal clogged, but it is turning ok? This may be due to a blockage in the pipe. If you look at the pipe work under your sink you will see that the disposal is connected to a pipe that should join to a U bend and providing it was installed correctly it should have a connector that can be undone. If you undo this connector the pipe will pull away and generally this is where most blockages occur. Remove the blockage and reconnect the pipe.